Grooves in gasket surfaces

Antworten
jgn
Beiträge: 14
Registriert: Mi 5. Okt 2022, 19:51

Grooves in gasket surfaces

Beitrag von jgn »

Hello, can anyone help me with this question: what is the purpose of the grooves in the surfaces of crankcase, cylinder and cylinder top? It looks as if it was meant for O-ring gaskets, but they are not shown in the spares list.
Grooves.jpg
Grooves.jpg (145.31 KiB) 648 mal betrachtet
Torsten
Beiträge: 115
Registriert: Di 6. Apr 2021, 14:07
Wohnort: Bad Oeynhausen

Re: Grooves in gasket surfaces

Beitrag von Torsten »

Hello,

you are searching for pos. 11 ?

regards Torsten
2024-11-03 08_34_04-Yamaha TX750 1974 USA CYLINDER HEAD - CYLINDER - buy original CYLINDER HEAD - CY.png
2024-11-03 08_34_04-Yamaha TX750 1974 USA CYLINDER HEAD - CYLINDER - buy original CYLINDER HEAD - CY.png (42.16 KiB) 634 mal betrachtet
jgn
Beiträge: 14
Registriert: Mi 5. Okt 2022, 19:51

Re: Grooves in gasket surfaces

Beitrag von jgn »

Thanks Torsten, sorry for not being very precise - no, I mean the grooves on the entire surfaces, see new picture
Grooves.jpg
Grooves.jpg (167.04 KiB) 623 mal betrachtet
schraubix
Beiträge: 144
Registriert: So 27. Nov 2011, 22:54

Re: Grooves in gasket surfaces

Beitrag von schraubix »

Hi Joerns
forget the Groovs.
Some people put Plasticworms in it but it is not necesseri.
Use the original Gaskets and everyehing will be okay.
schraubix
jgn
Beiträge: 14
Registriert: Mi 5. Okt 2022, 19:51

Re: Grooves in gasket surfaces

Beitrag von jgn »

Ok, thank you very much!
Antworten